Honeywell Lynx Plus Series - Record Custom Voice Descriptors

Lynx Plus Series Installation and Setup Guide
- 54 -
✻85 Record Custom Voice Descriptors
Use this mode to record up to 5 custom voice descriptors. To enter this mode, enter ✻85 while in
Programming mode.
Note: Entering a number other than one specified will give unpredictable results.
85
8585
85
REC
REC REC
REC VOICE
VOICE VOICE
VOICE DESCR
DESCRDESCR
DESCR
Assign Custom Voice Descriptors
Entering “1” advances to the next prompt below. Entering “0” exits mode, upon which
“85” prompt blinks, indicating the mode is inactive.
SELECTIONS
0 = exit mode
1 = enter mode
A
AA
A
CUSTOM
CUSTOM CUSTOM
CUSTOM DESC
DESCDESC
DESC #
Custom Descriptor Number
Record up to 5 custom words. Enter 7 + d + [✻]
Note: d = 0-4, each representing custom word 70, 71, 72, 73, or 74, respectively. Any
existing word will be announced
Press [#] to start recorder. Begin speaking immediately after the third beep. Speak the
desired word clearly near the microphone. Recording stops after 1.5 seconds.
SELECTIONS
0 = exit mode
1 = enter mode
6 = accept word and ready to record next descriptor prompt (A….7d)
[#] = re-record descriptor
00 = exit Record mode after pressing 6 to accept word
Press any key to repeat the recorded word.