Honeywell Micro-Pro UDC1200 User Manual

1
UDC 1200 Start-up Guide Rev 2
HONEYWELL UDC1200 MICRO-PRO
1. Mounting Page 2
2. Wiring Page 3
3. Select Mode Page 5
4. Configuration Mode Page 6
5. Setup Mode Page 12
6. Operator Mode Page 15
7. Automatic Tuning Mode Page 16
8. Product Information Mode Page 17
9. Installing Option Modules Page 19
10. Error Fault Indications Page 20
11. Lost Lock Code Page 21
The full user’s manual can be downloaded from Honeywell Web page
HONEYWELL UDC1200/1700 MICRO-PRO
Universal Digital Controller
Start-Up Guide

Honeywell Micro-Pro UDC1200 Specifications

General

Model	UDC1200
Input Types	Thermocouple, RTD
Output Types	Relay
Control	On/Off, PID
Power Supply	24 VAC/VDC, 100-240 VAC
Communication	RS-485
Dimensions	96 x 96 x 100 mm
Enclosure Rating	IP65
Alarms	2 Configurable Alarms

Summary

Mounting

Panel-Mounting

Describes how to install the instrument onto a mounting panel.

Wiring

Rear Terminal Wiring

Details the rear terminal connections for UDC 1200 models.

Select Mode

Entry into Select Mode

Explains how to force the unit to enter Select Mode.

Navigating Select Mode

Describes how to select and enter desired modes from Select Mode.

Unlock Codes

Details the unlock codes required for restricted modes.

Configuration Mode

Setup Mode

Operator Mode

Automatic Tuning Mode

Navigating Automatic Tune Mode

Describes how to navigate and set values within the Automatic Tuning Mode.

Product Information Mode

Navigating Product Information Mode

Details how to move through and view product information parameters.

Installing Option Modules

Error Fault Indications

Lost Lock Code/Password

Lock Code View

Provides read-only access to view configuration lock codes.

Entry and Navigating Lock Code View

Explains how to enter and navigate the Lock Code View mode.