Honeywell MicroniK 200 R7426D - Configuration and Control Parameters

R7426D UNIVERSAL INPUT CONTROLLER
3 EN1B-0204GE51 R0403
CONFIGURATION AND CONTROL PARAMETERS
Config. Par.
No. Name
Description Default Setting Actual Value
C.01 DIR/REVY1 Selects the output action of Y1 to adapt the valve or damper direction Dir
Dir
Rev
Direct acting output signal
Reverse acting output signal
C.05 CPATYP Selects the Control Point /SetPoint Adjustment type
0
Potentiometer
range
CPA/SPA
range
Sensor / Remote Setpoint Unit
Type Numbers
0 internal CPA: ±10% internal
1 100kΩ...0Ω CPA: ±10% 43193982-001
2 100kΩ...0Ω SPA: 0...100% 43193982-001
C.06 YRange Selects the output control range
1
0
1
2 ... 10Vdc
0 ... 10Vdc
C.12 X2ext Enable / Disables the X1 sensor input to be used for both X1 and X2 inputs
0
0
1
2
X2 installed
X1 signal used for X2
X2 disabled
C.13 LimTyp Limitation type determines whether the limit function is low or high. 1
0
1
Low limit
High limit
C.14 Senstyp Sensor type determines automatic detection or manual selection of
NTC sensor type
0
0
1
Auto detection T3
NTC sensor type T3
C.15 Y1CTRF Control function
1
0
1
Direct control behaviour
Reverse control behaviour
C.22 Adr
1)
Sets the serial communication address, used for service or maintenance.
254
0
255
Min.
Max.
C.23 DefProg Initiates the default programming.
0
0
1
No Defaultprogramming
Initiates Defaultprogramming
C.24 UStartPoint Start point (0%) of X1 and X2 span adjustment
0
0
10V
Min.
Max. (resolution 0.1V)
C.25 UEndPoint End point (100%) of X1 and X2 span adjustment
10
0
10V
Min.
Max. (resolution 0.1V)
C.26 OffDelay Off delay for On/Off output
0
0
60min
Min.
Max. (resolution 1min)
1)
actual value will not be changed during reset to default parameter
For detailed information of configuration parameters see chapter Configuration Settings.
Table 3. Configuration Parameters R7426D