Honeywell MM14CCS Service Manual

TROUBLESHOOTING
Problem
- 2 -
Analysis
Does not run
·If the protector trip or fuse is blown.
·Please wait for 3 minutes and start again, protector
device may be preventing unit to work.
·If batteries in the remote controller exhausted.
·If the plug is not properly plugged.
Run a short while
only
Run but not cool
Do not run and water
full indicator lights
·If the set temperature is close to
you can low the set temperature.
·Air outlet be blocked by obstacle.
Take the obstacle away.
room temperature,
·If the door or window open.
·If there is other heater appliance work,
like heater or lamp, etc...
·The air filter is dirty, please clean it.
·Air outlet or intake be blocked.
·Set temperature is too high.
·Drain the water into a prepared container by the drainage
pipe on the rear panel of the unit.
If still doesn't work, please consult a qualified technician.

Honeywell MM14CCS Specifications

General

Type	Monobloc mobile air conditioner
Timer	Yes
Timer type	Digital
Hose length	1.2 m
Noise level	53 dB
Hose diameter	127 mm
Refrigerating medium	R410A
Cooling capacity (max)	14000 BTU/h
Dehumidifying capacity	1.875 l/h
Timer duration (maximum)	24 h
Air conditioner functions	Cooling, Dehumidifying, Fan
Suitable for room area up to	46.5 m²
Cooling capacity in watts (nominal)	- W
Cooling energy efficiency (EER, W/W)	-
Display type	LCD
Product color	Black, Silver
Connected load	1500 W
Hourly energy consumption (heating)	- kWh

Weight and Dimensions

Depth	170.18 mm
Width	391.16 mm
Height	635 mm