16
Clearing alarm:
Press the key.
All alarm messages, with the exception of AL2, are also reset
by switching off the operating voltage. AL2 can only be reset using
the key.
10 Problem solving
Fault Cause Remedy
Evaporator fan does Evaporator sensor T2 Refit
not switch on during has fallen out sensor.
cooling when the of the fins.
programmed setting of
parameter E11 is set
to position 3
(fan run-on).
11 Warranty conditions
I Warranty is provided for a period of 12 months, starting
at the date the item was delivered. Proof of this should be
furnished in the form of a delivery note or invoice.
I All functional faults caused by poor workmanship or faulty
materials will be repaired free of charge during the warranty
period.
I More extensive claims, in particular for consequential damage, are
excluded.
I Damage or malfunctioning caused by the equipment being
handled incorrectly or by non-compliance with the operating
instructions shall not be covered by the warranty.
The warranty shall be invalidated if any work is carried out
on the appliance.
To Next Page
Loading...
