A28-1146-102-00
Radar Facts
5-69
GROUND MAPPING
Ground mapping operation is selected with the GMAP button An
example of ground map display is shown in figure 5-49.Turn the TILT
control down until the desired amount of terrain is displayed. The
degreeofdown-tiltwilldependuponthetypeofterrain,aircraftaltitude,
and selected range. Tables 5-13and 5-5showtiltsettings formaximal
ground target display at selected ranges.
Ground Mapping Display
Figure 5-49
For the low ranges (5, 10, 25, and 50 NM), the transmitter pulsewidth is
narrowed and the receiver bandwidth is widened to enhance the
identification ofsmall targets. Inaddition,the receiver STC characteristics
are altered to better equalize ground target reflections versus range. As
a result, the preset gain position is generally used to display the desired
map. The pilot can manually decrease the gain to eliminate unwanted
clutter.
To Next Page
Loading...
