A28-1146-102-00
Operating Controls
3-28
D Entry Method -Selected by sequencing through the roll offset,
pitch offset, and roll gain menus with the STAB button. (Refer to
Section 5, Radar Facts, table 5-10.)
D Control - Pull the GAIN knob out and use it.
D Exit Method - Push the GAIN knob in. Push STAB to exit and
save settings.
NOTES: 1. If installation is configured only for roll offset
adjustment, pushing the STB button saves and exits
after the roll offset adjustment is made.
2. Upon exiting, stabilization may be either OFF or ON
depending on how many times it was pushed during
the procedure. Be sure to set stabilization OFF or ON
as desired.
3. If uponentering theadjustment mode,no changesare
desired, keep the gain knob pushed in and repeatedly
push STAB until the mode is exited.
To Next Page
Loading...
