6 PRO-2200 Intelligent Controller PRO22ICInstallation Guide
Disclaimer
Product Liability; Mutual Indemnification
In the event that a Customer receives a claim that a Product or any component thereof
has caused personal injury or damage to property of others, Customer shall immediately
notify Engineering Systems in writing of all such claims. Engineering Systems shall
defend or settle such claims and shall indemnify and hold Customer harmless for any
costs or damages including reasonable attorneys’ fees which Customer may be required
to pay as a result of the defective Product or the negligence of Engineering Systems, its
agents, or its employees.
Customer shall hold harmless and indemnify Engineering Systems from and against all
claims, demands, losses and liability arising out of damage to property or injury to
persons occasioned by or in connection with the acts or omissions of Customer and its
agents and employees, and from and against all claims, demands, losses and liability for
costs of fees, including reasonable attorneys’ fees, in connection therewith.
Unpacking Procedure
CAUTION
If any damage to the shipment is noticed before unpacking, a claim must be filed with the
commercial carrier.
All containers should be opened and unpacked carefully in order to prevent damage to
the contents.
The following steps are used to unpack equipment in preparation for installation:
1. Open the container and remove the unit(s) and all packing material. Retain the
container and all packing materials. They may be used again for reshipment
of the equipment, if needed.
2. Inspect the contents for shortage. If items are missing items, contact the order entry
department at 800-323-4576.
3. Visually check contents. If damage is discovered, perform the following:
If shipping caused damage to the unit, a claim must be filed with the
commercial carrier.
If any other defect is apparent, call 800-323-4576 for a return authorization.
To Next Page
Loading...
Need help?
General
