Need help?Do you have a question about the Honeywell Q4000 and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | Q4000 |
| Category | Measuring Instruments |
| Language | English |
Overview of the Q4000 electromagnetic water meter for installation.
Guidance on protecting the meter from sunlight, high temperatures, and downward display mounting.
Recommendations for providing adequate space around the meter for piping work and tightening bolts.
Advice on avoiding strong electromagnetic fields and stray electrical currents for optimal performance.
Instructions to avoid corrosive agents and continuous vibration for meter longevity.
Note on observing submergence depth when installing in flooded chambers.
Insert the studding in the lower two bolts and fix the bolts to the flanges.
Place the electromagnetic meter on the studs and set it in the desired position, avoiding damage.
Insert remaining studs, tighten bolts slightly, ensure pipe centre alignment, and fit gaskets.
Tighten nuts diagonally in sequence to fully seal the gaskets.
Ensure pipes are clean and always filled completely with flowing fluid for proper operation.
Warning against allowing any solid substances inside the pipe during installation.
Recommendation for installing the meter on a straight section of pipe for accurate measurement.
Warning to prevent any air from being sucked into the piping system.
Manufacturer's declaration of compliance with relevant EU directives for the Q4000 meter.
To Next Page
