What to do if Honeywell RPLS730B1000/U programs do not run as expected?
If programs on your Honeywell Switch aren't running as expected, ensure the switch is properly programmed. Also, be aware that '- : - -' indicates an inactive program. If you're using a 12-hour format, confirm that 'PM' is displayed when an afternoon time is set.
Why does my Honeywell RPLS730B1000/U reset itself?
If your Honeywell Switch resets unexpectedly when controlling a relay or contactor, the load is likely the cause. To resolve this, install a snubber (AC130-03) at each relay/contactor.
How to fix a blank display on a Honeywell RPLS730B1000/U?
To resolve a blank display on your Honeywell Switch: * Verify the circuit breaker at the main panel. * Ensure the ON/OFF selector is set to ON. * Try resetting the switch using a paper clip.
Why is the display on my Honeywell RPLS730B1000/U Switch faded?
A faded or irregular display on your Honeywell Switch may be due to the ambient temperature being below freezing.
General| Amperage | 15A |
|---|---|
| Programmable | Yes |
| Color | White |
| Housing Material | Plastic |
| Switch Type | Single Pole |
| Maximum Operating Temperature | 104°F (40°C) |
| Wattage | 1/2 HP |
| Compatibility | Incandescent, Halogen, LED, CFL |
| Application | Indoor |
| Features | 7-Day Programming |
| Electrical Rating | 15A |
| Voltage | 120/240 VAC |
To Next Page