3. Press or to set the temperature for this time period, then press SET.
4. Set time and temperature for the next time period (Leave). Repeat steps 2 and 3 for each time period.
5. Press RUN to save & exit.
NOTE: Make sure the thermostat is set to the system you want to program (Heat or Cool).
Program schedule override (temporary)
Press or to immediately adjust the temperature. This will temporarily override the temperature setting
for the current time period.
“Temporary” will appear on the display and the current program period will flash.
The new temperature will be maintained only until the next programmed time period begins.
To cancel the temporary setting at any time, press RUN.
Program schedule override (permanent)
Press HOLD to permanently adjust the temperature. This will override the temperature settings for all time
periods.
To Next Page
Loading...
Need help?
General
