Honeywell S7999D SOLA - Page 27

27 65-0315—02
Individual R7910 or R7911
Configuration Parameters
Table 30 and Table 31 displays system configuration
parameters for individual controls.
Fig. 57. System configuration (R7910 shown).
Fan Parameters
Table 32 displays fan parameters.
Fig. 58. Fan configuration.
Table 30. R7910Hydronic
System Configuration Parameters.
Parameter Comment
Flame sensor type Flame rod
UV power tube
UV power tube with spark interference
None
Modulation output 4-20mA
0-10V
Fan PWM
Blower/HSI Blower
Hot surface ignition
Temperature units Fahrenheit
Celsius
Anti short-cycle time ___hour ___min ___sec
Alarm silence time ___hour ___min ___sec
Power up with
Lockout
Clear lockout
Do NOT clear lockout
STAT & EnviraCOM
remote stat
Enabled
Disabled
Table 31. R7911 System
Configuration Parameters.
Parameter Comment
Flame sensor type Flame rod
UV
Modulation output 4-20ma
0-10V
Fan PWM
Blower/HSI Blower
Hot surface ignitor
Temperature units Fahrenheit
Celsius
Anti short cycle time ___hour ___min ___sec
Alarm silence time ___day ___hour ___min
Power up with lockout Clear lockout
Do NOT clear lockout
Inlet connector type 0-15 psi
0-150 psi
UNCONFIGURED
Stack connector type 10k NTC dual safety
10k NTC single non-safety
12k NTC single non-safety
UNCONFIGURED
Header 4-20ma
UNCONFIGURED