Closemount
Screws
Fig. 16
Canopy
Canopy
Receiver
Hook
Canopy
Cover
Fig. 15
Fig. 17
17. Raise the fan and place the canopy on the hook of
the mounting bracket. Then, insert the receiver into
the mounting bracket with the at side facing the
ceiling (Fig. 17).
15. Remove the canopy cover from the bottom of the
canopy (Fig. 15).
Helpful Hint: The downrod, yoke cover and
canopy cover are not used in this type of
installation.
Closemount Screw
16. Align the canopy with the holes in the top of motor
assembly. Then, secure the canopy to the top of
the motor assembly using the three closemount
screws from the hardware bag (Fig. 16).
CLOSEMOUNT INSTRUCTIONS
10
To Next Page
Loading...
