1
2
3
4
5
6
Fig. 24
Fig. 25
Fig. 26
LED Indicator
Battery
Battery
Compartment
Fan Power
Wall
Bracket
Screw
Mounting
Slot
14
24. Remove the battery cover (not shown) from the
back of the remote. Insert the battery into the
remote; ensure polarity of battery matches the
polarity indicated in the battery compartment
-- positive (+) to positive (+) and negative (-) to
negative (-). Replace the battery cover and press
the fan power button on the remote to ensure the
LED indicator illuminates and the remote turns on
the fan (Fig. 24). Note: If remote doesn’t turn on the
fan, see TROUBLESHOOTING (page 17).
25. To operate the fan using the remote, press and
release the following buttons:
1 - High fan speed
2 - Medium fan speed
3 - Low fan speed
4 - Fan Power - Turns the fan off.
Light Delay Off mode - Press and hold the fan
power button (4) for ve seconds, which will turn
off light after one minute. The LED indicator on
the remote will ash four times to conrm mode
setting.
5 - Light Control:
Incandescent Bulbs - Press light control to turn
lights off and on. Press and hold light control to
dim or brighten the lights.
CFL Bulbs -Turns the lights on and off.
Note: Dimmer function does not work with CFL.
6 - D/CFL Switch: Switch should be set to “CFL”
to correspond with the CFL. Flip to “D” if you
change to incandescent, which will enable the
dimming function.
26. Use the two wall bracket screws from the remote
pack to mount the wall bracket to a wall (Fig. 26).
Note: The mounting slot on the back of the remote
hangs on top edge of the wall bracket.
REMOTE CONTROL
To Next Page
Loading...
