Honeywell ScanPal EDA51 Series Quick Start Guide

10
Charge the Mobile Computer
The EDA51 mobile computer ships with a partially charged
battery. Charge the battery with a EDA51 Series charging device
for a minimum of 4.5 hours. Using the computer while charging
the battery increases the time required to reach a full charge.
EDA51 mobile computers are designed for use with the
following EDA51 charging accessories: Single Charging Dock,
Quad Bay Charge Base, Quad Battery Charger, and USB Cable.
For more information about accessories, see the “ScanPal
EDA51 Mobile Computer Accessories Guide” at
www.honeywellaidc.com.
We recommend the use of Honeywell accessories and
power adapters. Use of any non-Honeywell
accessories or power adapters may cause damage not
covered by the warranty.
Ensure all components are dry prior to mating the
computers and batteries with peripheral devices.
Mating wet components may cause damage not
covered by the warranty.

Honeywell ScanPal EDA51 Series Specifications

General

Display Size	5.0 inches
Operating Temperature	-10°C to 50°C (14°F to 122°F)
Drop Specification	1.2 m (4 ft) to concrete
IP Rating	IP64
Processor	Qualcomm Snapdragon 450, 1.8 GHz octa-core
Camera	13 MP rear
Battery	4000 mAh
Connectivity	Wi-Fi 802.11 a/b/g/n/ac, Bluetooth 4.2
Scanner	1D/2D barcode scanner
Storage Temperature	-20°C to +70°C (-4°F to +158°F)
GPS	Yes
Display Resolution	1280 x 720
Storage	16 GB