2
System operation settings
1 Press the Menu to cause the Mode and Fan menus
to appear.
2 Press Mode ( ) to cycle through the available
modes.
NOTE: Available System modes vary by model and
system settings.
System modes:
‒ Heat
‒ Cool
‒ Off
Fan operation settings
Setting degrees Fahrenheit (F) or Celcius (C)
Damage can occur if the compressor is restarted
too soon after shutdown. This feature forces
the compressor to wait for a few minutes before
restarting.
During the wait time, the display will flash the
message Cool On (or Heat On if you have a heat
pump). When the safe wait time has elapsed, the
message stops flashing and the compressor turns on.
Built-in compressor protection
Message flashes until safe
restart time has elapsed.
+
+
+
1 Press and hold Menu (center) for approximately
3 seconds to enter advanced menu.
2 Change setup option 125 by pressing Edit ( ) to
change the value: 0 = Fahrenheit, 1 = Celsius.
3 Press Done to Save and return to the main menu
screen.
1 Press Menu to cause the Mode and Fan menus to
appear.
2 Press Fan ( ) to cycle through Fan modes.
NOTE: Available Fan modes vary with system
settings.
Fan modes:
‒ Auto: Fan runs only when the heating or cooling
system is on.
‒ On: Fan is always on.
+
To Next Page
Loading...
Need help?
General
