EasyManua.ls Logo

Honeywell T822 - Thermostat Configuration and Mounting; Set Heat Anticipator; Mounting the Thermostat Cover

Honeywell T822
4 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
69-1711 J.S. 2-04 www.honeywell.com/yourhome
T822 THERMOSTAT
Printed in U.S.A. on recycled
paper containing at least 10%
post-consumer paper fibers.
Automation and Control Solutions
Honeywell International Inc. Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MN 55422 Scarborough, Ontario
M1V 4Z9
IF YOU HAVE A PROBLEM
Customer Assistance
Please read and follow the provided instructions for this
thermostat. For additional information, go to
www.honeywell.com/your home
or call Honeywell
Customer Care at 1-800-468-1502.
Before calling, please have the following information
available:
Thermostat model number and date code (refer to
Fig. 6 for the location of the model number and date
code).
Type of heating system (for example: gas or oil; warm
air, hot water).
If. . . Then. . .
Heating system
does not come on.
Make sure the temperature
setting is above the room
temperature.
Make sure the circuit breaker
is not tripped and reset it if
necessary.
Make sure the power switch at
the equipment is in the On
position.
Wait 5 minutes for the system
to respond.
Heating system runs
too long to maintain
a comfortable
temperature.
Verify the thermostat is level.
Adjust heat anticipator lever
clockwise one scale mark (see
Fig. 7). Do not adjust heat
anticipator below .3 Amps.
Heating system
needs to run longer
to maintain a
comfortable
temperature.
Verify the thermostat is level.
Adjust heat anticipator lever
counterclockwise, in the
direction of the arrow, one
scale mark (see Fig. 7).
Temperature lever
cannot be set to the
highest and/or
lowest setting on the
temperature scale.
Adjust temperature range
stops (see Fig. 8).

Other manuals for Honeywell T822

Related product manuals