10. If using the Screen Blanking feature, install the screen
blanking box or switch.
11. Press the power switch on the back of the Thor VM1 dock.
12. Press the power button on the front of the Thor VM1.
Note: Have the following information available before setting up
your Thor VM1:
•
Network ID (SSID) of the Access Point
•
WEP key or LEAP authentication credentials
Setting up the Thor VM1 Software
1. Connect the Thor VM1 to an external power source.
2. Press the Power button.
3. For a 12-key Thor VM1, you may want to attach a USB keyboard
via the USB adapter cable during the setup process.
4. Accept the EULA.
5. Calibrate the touch screen.
6. Set the date and time.
7. Edit the radio parameters.
8. Edit the RFTerm Terminal Emulation parameters (optional).
9. Perform a reboot.
To Next Page
Loading...
Need help?
General
