Refer to the Thor VM1 User’s Gouide, available at
www.honeywellaidc.com, for further information about
ActiveSync information.
Wireless Network Configuration
If the access point uses an authentication protocol (WEP, LEAP,
etc.), your radio must use the same authentication. Contact your IT
department for any necessary keys, login credentials, or certificates.
Refer to the Thor VM1 User’s Guide, available at
www.honeywellaidc.com, for further information or for configuration
options not listed here.
1. Tap Start > Programs > Summit > SCU or tap the Summit
Client Utility icon on the desktop.
2. Tap the Admin Login button and enter the password (default =
SUMMIT).
3. Tap the Profile tab and make sure the Default profile is selected.
4. Select SSID and enter the SSID of the access point.
5. If the access point is using WPA or WPA2:
5a. Set Encryption to WPA TKIP, WPA CCKM, WPA2 AES,
WPA2-TKIP, or WPA2 CCKM.
5b. Set EAP type to PEAP/MSCHAP, PEAP/GTC, WPA/
LEAP, EAP-FAST or EAP-TLS.
5c. Set Auth Type to Open unless using WEP/LEAP. For
WEP/LEAP set Auth Type to correspond to the access
point’s setting.
5d. Tap the Credentials button and complete the entries on
the popup screen.
5e. Tap OK. Skip to step 8.
To Next Page
Loading...
Need help?
General
