6. If the access point is using WPA PSK:
6a. Set Encryption to WPA PSK, WPA2-PSK-TKIP, WPA-
PSK-AES, or WPA2 PSK.
6b. Set EAP type to None.
6c. Tap the WEP keys/PSKs button and enter the PSK .
6d. Tap OK. Skip to step 8.
7. If the access point is using LEAP:
7a. Set Encryption to WEP EAP.
7b. Set EAP Type to LEAP.
7c. Set Auth Type to correspond to the access point’s set-
ting.
7d. Tap the Credentials button and enter the User Name and
Password.
7e. Tap OK. Skip to step 8.
8. Tap the Commit button to save the radio configuration.
9. Tap the Main tab. Wait for a radio connected message.
10. Tap the Admin Logout button when finished.
11. Reboot the Thor VM1.
Setting Up AppLock (CE 6.0 only)
Thor VM1 devices are shipped to boot in Administration mode. In
this mode, the user has full access to the device and no password is
needed. After the administrator completes the process below, the
Thor VM1 switches to end-user mode and restricts access to only
the specified application(s).
To Next Page
Loading...
Need help?
General
