Honeywell VisionPRO - Advanced Features and Configuration; Unregistering the Thermostat; Disconnecting from Wi-Fi; Adaptive Intelligent Recovery (AIR)

Unregistering Thermostat
If you remove the thermostat from your Total Connect Comfort website account (for example, you’re
moving and leaving the thermostat behind), the message center will scroll UNREGISTERED FROM
TOTAL CONNECT for 3 minutes.
After that, it will alternate displaying REGISTER AT TOTAL CONNECT, the MAC ID and the MAC CRC.
Disconnecting Wi-Fi
If you disconnect the thermostat from your Wi-Fi network (for example, you’re replacing your router):
1. Enter system setup (see page 30).
2. Change setting 900 to 0 (see page 35).
The Message Center will display Wi-Fi DISCONNECTED for 1 minute.
After that it will display Wi-Fi SETUP.
Special Features
Adaptive Intelligent Recovery (AIR)
This feature allows the thermostat to “learn” how long the heating/cooling system takes to
reach programmed temperature settings, so the temperature is reached at the time you set. For
example: Set the Wake time to 6:00 am, and the temperature to 70°. The heat will come on before
6:00 am, so the temperature is 70° by 6:00 am. The message “Recovery” is displayed when the
system is activated before a scheduled time period.
Note: System setting function 0530 controls AIR. See “AIR” on page 34.