Honeywell VISTA-20PSeries - Fire Alarm System (contd); Manually Initiating a Fire Alarm; Using the Panic Key(s) Assigned for FIRE Emergency

– 47 –
Fire Alarm System
(cont’d)
THIS SECTION APPLIES ONLY TO RESIDENTIAL SYSTEMS
Manually
Initiating
a Fire Alarm
1. Should you become aware of a fire emergency before your smoke or
heat detectors sense the problem, go to your nearest keypad and
manually initiate an alarm by pressing the panic key assigned for
FIRE emergency for 2 seconds (see below). If a key pair has been
assigned for fire, press both keys at the same time. See the
Using
the Panic Keys
section below for further details.
2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and notify
your local Fire Department immediately.
4. If no flames or smoke are apparent, investigate the cause of the
alarm. The zone number(s) of the zone(s) in an alarm condition will
be displayed at the keypad.
Using the
Panic Key(s)
Assigned for
FIRE
Emergency
A key or key pair may have been assigned for manually initiating a
FIRE alarm. See the
Panic Keys
section for key assignments.
For convenience, indicate the key or key pair assigned for fire below.
Individual Keys
A B C
Press the individual key assigned for fire for 2 seconds.
OR
Key Pairs
1
OFF
and
✱
READY
✱
READY
and
#
3
STAY
and
#
DISPLAYS FOLLOWING MANUAL INITIATION OF A FIRE ALARM
*-6)

ALARM
FIRE
AC
ALPHA DISPLAY KEYPAD
FIXED-WORD KEYPAD
P
ress both keys of the key pair
a
ssigned for fire at the same time.