Honeywell W7761A - Page 50

EXCEL 10 W7761A INPUT/OUTPUT DEVICE
50 74-2699
Table C1. Input/Output Points (Right Continued).
Share (SH), Map (MA), Direct Access (DA)
E-Vision (EV): Calibrate (C), Monitor (M),
Parameter (P), Schematic (S)
Hardware Configuration (HW),
Manual Point (MN), Test (TS)
SH MA DA EV HW MN TS Comments
X X DI3Sel1Type: Refer to the description for DI1Sel1Type.
X X DI4Sel1Type: Refer to the description for DI1Sel1Type.
X X DI1Sel2Type specifies the sensor type and function connected to DigitalIn0S2
through DigitalIn3S2. The valid enumerated list of logical digital states for
DI1Sel2Type is listed in the Eng. Units/States column.
X X DI2Sel2Type: Refer to the description for DI1Sel2Type.
X X DI3Sel2Type: Refer to the description for DI1Sel2Type.
X X DI4Sel2Type: Refer to the description for DI1Sel2Type.
X X DO1Type specifies which logical digital output function is assigned to the digital
physical output according to the enumerated list that is shown in the Eng.
Units/States column.