Honeywell W7761A - Page 62

EXCEL 10 W7761A INPUT/OUTPUT DEVICE
62 74-2699
Table C3. Status Points (Right Continued).
Share (SH), Map (MA), Direct Access (DA)
E-Vision (EV): Calibrate (C), Monitor (M),
Parameter (P), Schematic (S)
Hardware Configuration (HW),
Manual Point (MN), Test (TS)
SH MA DA EV HW MN TS Comments
InOverride:
This field is not supported and is set to 0 (FALSE).
LockedOut:
This field is not supported and is set to 0 (FALSE).
ManualControl:
This field is not supported and is set to 0 (FALSE).
MechanicalFault:
This field is not supported and is set to 0 (FALSE).
ObjectId: is set to the current value of nviRequest.object_id
OpenCircuit:
This field is not supported and is set to 0 (FALSE).
OutOfLlimits:
This field is not supported and is set to 0 (FALSE).
OutOfService:
This field is not supported and is set to 0 (FALSE).
OverRange:
This field is not supported and is set to 0 (FALSE).
SelfTestInProgress:
This field is not supported and is set to 0 (FALSE).
UnableToMeasure:
This field is not supported and is set to 0 (FALSE).
UnderRange:
This field is not supported and is set to 0 (FALSE).