Trigger
The following bar codes will allow you to use the scanner in
Manual Trigger - Normal Mode (need to press the trigger to
read) or Presentation mode (the scanner is activated when it
“sees” a bar code).
Note: Presentation Mode continuously draws power, so use of
the external power supply is recommended for this mode.
Temporary Streaming Presentation™ Mode
When the scanner is in the base, press the page button on the
base to begin Streaming Presentation Mode. The scanner acts
as a presentation scanner for 10 seconds. If a bar code is
scanned before the 10 second timeout is reached, the timer
starts over. Lift the scanner from the base to return to manual
triggering. To change the timeout from 10 seconds, scan the
Temporary Streaming Presentation Timeout code then scan
the length of the timeout in milliseconds from the Programming
Chart. Scan Save to save your timeout.
10 seconds = 10,000 ms. Maximum timeout is 30 minutes or
1,800,000 ms.
Manual Trigger - Normal
(Default)
Temporary Streaming Presentation Timeout
To Next Page
Loading...
