To Next PageTo Next Page
Need help?Do you have a question about the Honeywell Enhanced Xenon 1902H and is the answer not in the manual?
General| Type | Handheld bar code reader |
|---|---|
| Sensor type | Laser |
| Scanner type | 1D/2D |
| Read rate (max) | 25 reads/s |
| Yaw reading angle | -65 - 65 ° |
| Tilt reading angle | 32.2 - 41.4 ° |
| Pitch reading angle | -45 - 45 ° |
| Light levels (direct sunlight) | 0 - 100000 lx |
| Linear (1D) barcodes supported | PDF417 |
| 2D (matrix & stacked) barcodes supported | - |
| Cable length | 3 m |
| Wireless range | 10 m |
| Bluetooth version | 2.1+EDR |
| Operating frequency | 2400 - 2500 MHz |
| Standard interfaces | Bluetooth, USB |
| Connectivity technology | Wired & Wireless |
| Certification | CE, UL |
| Product color | Grey, White |
| LED indicators | Yes |
| International Protection (IP) code | IP41 |
| Sustainability certificates | RoHS |
| Battery life | 14 h |
| Charging time | 4.5 h |
| Battery capacity | 1800 mAh |
| Power consumption | 1000 mA |
| Power source type | Battery, USB |
| Number of reads per charge | 50000 |
| Power consumption (standby) | 0.5 W |
| Power consumption (typical) | 5 W |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | 0 - 50 °C |
| Operating relative humidity (H-H) | 0 - 95 % |
| Cables included | USB |
Weight and Dimensions| Depth | 160 mm |
|---|---|
| Width | 71 mm |
| Height | 104 mm |
| Weight | 214 g |
| Base weight | 179 g |
| Base dimensions | 132 x 102 x 81 mm |
Instructions for assembling the power supply unit if it is included.
Procedure for connecting the scanner via USB.
Procedure for connecting the scanner via Keyboard Wedge.
Procedure for connecting the scanner via RS232 Serial Port.
Procedure to unlink a scanner from the base.
Guidance on how to properly scan barcodes.
Scan barcode to program scanner for USB serial emulation.
Scan barcode to configure scanner for Epic software application.
Scan barcode to configure scanner for Meditech software.
Configures scanner and base to quiet modes for patient care.
Silences scanner/base; LED/aimer flash 5 times on scan.
Silences scanner/base; LED/aimer remain lit 1 sec on scan.
Sets scanner for very low beep; silences most system sounds.
Sets all sounds to on, but at a low volume.
Adds a Code ID prefix to all symbologies at once.
Contact info for support, service, and repair.
Information on product warranty.
Link to localized documentation and User's Guide.
Legal disclaimer regarding document content and liability.
