Need help?Do you have a question about the Honeywell Xenon Ultra 1962 Series and is the answer not in the manual?
Instructions for assembling the power supply unit for the scanner base.
Steps to connect the scanner to a computer via USB.
Steps to connect the scanner using a keyboard wedge interface.
Steps to connect the scanner via an RS232 serial port.
Procedure to establish communication between the scanner and its base.
Procedure to disconnect a previously linked scanner from its base.
Guidance on using the scanner's aiming beam for barcode reading.
Barcode to reset the scanner to its original factory settings.
Configure the scanner to emulate a standard RS232 COM port over USB.
Configure the scanner for USB PC keyboard emulation.
Selectable country codes to set the keyboard layout for the scanner.
Options for manual or automatic scanner activation.
Options to add or remove characters after scanned data.
Adds a Code ID prefix to all scanned symbologies.
Enables or disables the transmission of function codes from the scanner.
Configures the scanner for Epic software.
Configures the scanner for Meditech software.
Silences scanner/base sounds; LED flashes on scan.
Silences scanner/base sounds; LED stays lit for 1 sec on scan.
Sets scanner to a very low beep, silences other sounds.
Sets all sounds to a low volume.
How to use the page button to locate the scanner or enter presentation mode.
Contact information and web portal for technical support.
Links to available product documentation online.
Information on how to access warranty details.
Information on patents related to the product.
To Next Page
General