Honeywell Voyager XP 1470g2D User Manual

Voyager™ XP 1470g Series
Corded Area-Imaging Scanner
Quick Start Guide
VG1470-EN-QS-01 Rev A
5/19

Honeywell Voyager XP 1470g2D Specifications

General

Operating Temperature	0°C to 50°C (32°F to 122°F)
Connectivity	USB, Keyboard Wedge, RS-232
Supported Barcodes	1D barcodes
Storage Temperature	-40°C to 60°C (-40°F to 140°F)
Humidity	5% to 95% (non-condensing)
Light Levels	0 to 100, 000 lux (9, 290 foot-candles)

Summary

Getting Started

Power Supply Assembly

Instructions for connecting the power supply unit to the scanner and power source.

Connecting the Scanner

USB Connection

Step-by-step guide for connecting the scanner to a computer using a USB cable.

Keyboard Wedge Connection

Procedure for connecting the scanner via a keyboard wedge interface to a computer.

RS232 Serial Port Connection

Instructions on how to connect the scanner to a computer using an RS232 serial port.

RS485 Connection

Diagram illustrating the connection of the scanner using an RS485 interface.

Reading Techniques

Standard Product Defaults

RS485 Interface Configuration

IBM POS Terminal Setup

Trigger Modes

Data Format Editor Instructions

Entering Data Format

Steps to initiate data format programming by scanning the 'Enter Data Format' symbol.

Saving Data Format Entries

Scan the 'Save' symbol to confirm and store data format configurations.

Clearing Data Formats

Scan the 'Clear All Data Formats' symbol to reset all programmed data formats.