Honeywell Voyager XP 1470g2D - Data Format Editor Instructions; Entering Data Format; Saving Data Format Entries; Clearing Data Formats

Data Format Editor Instructions
The following are abbreviated instructions for entering a data
format. For complete instructions refer to your User Guide.
Step 1. Scan the Enter Data Format symbol.
Step 2. Primary/Alternate Format: scan 0 for Primary Format
Step 3. Terminal Type: scan 099 for any terminal type
Step 4. Code I.D.: scan 99 for any bar code type
Step 5. Length: scan 9999 for any length bar code.
Step 6. Editor commands: use the Programming Chart that
follows.
Step 7. Scan Save to save your entries.
Enter Data Format
Clear All Data Formats
Save