To Next PageTo Next Page
Need help?Do you have a question about the Honeywell Voyager 147 Series and is the answer not in the manual?
Provides installation and programming instructions for Voyager XP scanners.
Steps to follow after opening the shipping carton to check for damage and contents.
Instructions for connecting the scanner or cordless base to a computer.
Details on connecting the scanner or base via USB port to a computer.
How to connect the scanner or base as a keyboard wedge to a PC.
Instructions for connecting the scanner or base via RS232 serial port.
How to connect the scanner or base for an IBM POS terminal interface.
Explains how the aiming dot functions and how to position the scanner for optimal barcode reading.
Steps to create custom defaults by scanning specific menu commands.
How to restore custom default settings to the scanner.
Using Plug and Play barcodes for instant scanner setup for common interfaces.
How to program for IBM PC AT keyboard wedge interface with a USA keyboard.
Allows operation in parallel with an integral keyboard for laptops.
Connecting to a serial port of a PC or terminal.
Connecting for an IBM POS terminal interface.
Explains the link between scanner, base/Access Point, and host system.
Steps to link a scanner to its charge base for communication and charging.
Explains what happens when a scanner loses communication with its base or Access Point.
Information regarding the scanner's rechargeable battery and its usage.
Important safety guidelines when handling and using lithium batteries.
Reboots the scanner and causes it to relink with the base or Access Point.
Specifies whether the scanner battery charges from external power or interface cable.
Disables or enables the paging button on the base or Access Point.
Programs scanner and base to beep when powered up.
Turns beeper On or Off for a good read indication.
Modifies the volume of the beep emitted on a good read.
Modifies the pitch of the sound emitted on a bad read or error.
Explains how to add data characters before or after scanned data.
Steps to add a prefix or suffix to symbologies using specific codes.
Clears single or all prefixes/suffixes for a symbology.
Recommends enabling only needed symbologies for best performance.
Setting min/max lengths to force fixed-length barcode data.
Settings for Codabar symbology, including On/Off and Start/Stop characters.
Programs scanner to read Codabar barcodes with specific check characters.
Temporarily adds Code I.D. prefix to all symbologies.
Scan barcode to output software revision and serial number.
Scanner displays programming code content when Test Menu is on.
PC-based functions for configuring scanner firmware and parameters.
Details mechanical, electrical, and environmental specifications for the 1470g scanner.
Details mechanical, electrical, radio, and environmental specs for the 1472g cordless scanner.
Details dimensions, voltage, current draw, charge time, radio, and temperature specs for the charge base.
Provides AIM and Honeywell identifiers and modifiers for various symbologies.
Lists AIM IDs, possible modifiers, and Honeywell IDs/Hex for linear symbologies.
Lists AIM IDs, possible modifiers, and Honeywell IDs/Hex for 2D symbologies.
Lists AIM IDs, possible modifiers, and Honeywell IDs/Hex for postal symbologies.
Maps ASCII control characters to keyboard shortcuts and functions across different modes.
Provides key reference maps for U.S. and European keyboards.
States repairs must be performed by an authorized service center.
Describes periodic checks for reliable and efficient operation.
How to clean the scanner or base housing with a soft cloth and mild solution.
Instructions for cleaning the scanner window to maintain reading performance.
Check interface cable and connector for wear or damage.
Information on replacing the standard interface cable attached to the scanner.
Steps to replace an interface cable in a charge base unit.
Steps for safely removing and replacing the battery in a cordless scanner.
Guide to isolate problems if the scanner is not functioning properly.
Guidelines to isolate problems with the base unit's functionality.
Steps to troubleshoot issues with the cordless scanner, focusing on battery and symbol reading.
General