180 Voyager XP User Guide
RS232 Receiver Time-out Range 0 - 300 seconds (*0) 232LPT### 33
RS232 Handshaking *RTS/CTS Off 232CTS0 34
Flow Control, No Timeout 232CTS1 34
Two-Direction Flow Control 232CTS2 34
Flow Control with Timeout 232CTS3 34
RS232 Timeout (Range 1-5100ms) 232DEL#### 34
*XON/XOFF Off 232XON0 35
XON/XOFF On 232XON1 34
*ACK/NAK Off 232ACK0 35
ACK/NAK On 232ACK1 35
Scanner-Bioptic Packet Mode *Packet Mode Off 232PKT0 35
Packet Mode On 232PKT2 35
Scanner-Bioptic ACK/NAK Mode *Bioptic ACK/NAK Off 232NAK0 36
Bioptic ACK/NAK On 232NAK1 36
Scanner-Bioptic ACK/NAK
Timeout
ACK/NAK Timeout (Range 1-5100ms)
*5100
232DLK##### 36
Cordless System Operation
Note: This section applies only to cordless systems. It does not apply to corded
scanners.
Replace a Linked Scanner Override Locked Scanner (Single Scanner) BT_RPL1 39
Base Power Communication
Indicator
*On :*:BASRED1 44
Off :*:BASRED0 44
Reset Scanner Reset Scanner RESET_ 45
Scan While in Base Cradle Scanning in Cradle Off BT_SIC0 45
*Scanning in Cradle On BT_SIC1 45
Shut Down Scanner In Cradle BT_SIC2 45
Base Charge Modes Base Charge Off BASCHG0 46
*External or Interface Cable Power BASCHG1 46
External Power Only BASCHG2 46
Page Mode *On BEPPGE1 46
Off BEPPGE0 46
Page Pitch Low (*1000 Hz) BEPPFQ1000 47
Medium (3250 Hz) BEPPFQ3250 47
High (4200) BEPPFQ4200 47
Beeper Pitch - Base Error *Razz (250) (min 200Hz) BASFQ2250 47
Medium (3250) BASFQ23250 47
High (4200) (max 9000Hz) BASFQ24200 47
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page
To Next Page
Loading...
Need help?
General