Voyager XP User Guide 79
Serial Trigger Mode
You can activate the scanner either by pressing the trigger, or using a serial trigger
command (see Trigger Commands on page 174). When in serial mode, the scanner
scans until a barcode has been read or until the deactivate command is sent. The
scanner can also be set to turn itself off after a specified time has elapsed (see
Read Time-Out, which follows).
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the scanner’s trigger when
using serial commands to trigger the scanner. Once the scanner has timed out, you
can activate the scanner either by pressing the trigger or using a serial trigger
command. After scanning the Read Time-Out barcode, set the time-out duration
(from 0-300,000 milliseconds) by scanning digits on the Programming Chart, then
scanning Save. Default = 30,000 ms.
Presentation Mode
Presentation Mode uses ambient light to detect barcodes. The LED dims until a
barcode is presented to the scanner, then the LED brightens to read the code. If the
light level in the room is not high enough, Presentation Mode may not work prop-
erly.
Note: If you are using a cordless charge base in Presentation Mode, the battery will not
charge unless the power supply is plugged into the base’s auxiliary power port.
Scan the following barcode to program your scanner for Presentation Mode.
Triggered Presentation Mode
This mode uses light to detect the presence of an object. Default = Ambient and
Scanner Light.
To Next Page
Loading...
Need help?
General