What to do if the bar code is displayed but not entered by my Honeywell Voyager 1450g2DHR?
If the bar code is displayed but not entered into your application, you likely need to program a suffix. Programming a suffix enables the Honeywell Scanner to output the bar code data along with the necessary key (like “CR”) to enter the data.
What to do if the bar code is displayed but not entered into the application by my Honeywell Voyager 1450g2DHR?
If the bar code is displayed but not entered into the application, you likely need to program a suffix. Programming a suffix enables the Honeywell Scanner to output the bar code data along with the necessary key (like “CR”) to enter the data.
Why won't my Honeywell Voyager 1450g2DHR Scanner read the bar code?
If your Honeywell Scanner won’t read your bar code, start by scanning the sample bar codes in the back of the manual. If the scanner reads those, then check that your own bar code is readable and that its symbology is enabled. If it still fails, scan All Symbologies.
How to fix a Honeywell Scanner that won't read bar codes?
If your Honeywell Scanner won’t read your bar code, start by scanning the sample bar codes in the back of the manual. If the scanner reads those, then check that your own bar code is readable and that its symbology is enabled. If it still fails, scan All Symbologies.
Why is my Honeywell Voyager 1450g2DHR Scanner not reading symbols well?
If the Honeywell Scanner isn’t reading symbols well, check these items: * The scanner window is clean. * The symbols aren’t smeared, rough, scratched, or exhibiting voids. * The symbols aren’t coated with frost or water droplets. * The symbols are enabled in the scanner or in the decoder to which the scanner connects.
What to do if Honeywell Voyager 1450g2DHR Scanner is not reading symbols well?
If the Honeywell Scanner isn’t reading symbols well, check these items: * The symbols aren’t smeared, rough, scratched, or exhibiting voids. * The symbols aren’t coated with frost or water droplets. * The symbols are enabled in the base or Access Point to which the scanner connects.
Why is the green LED not illuminated on my Honeywell Voyager 1450g2DHR Scanner?
If the green LED on your Honeywell Scanner isn’t illuminated, verify the following: * The scanner is correctly placed in the base. * There is external power or 12 volt host power. * Charge mode is turned on. * The battery is not bad or deeply discharged.
What to do if the red LED isn't illuminated on Honeywell Voyager 1450g2DHR?
If the red LED isn’t illuminated on your Honeywell Scanner, check that: * The power cable is connected properly and there is power at the power source. * The host system power is on (if external power isn’t used).
How to fix the aimer if it isn't illuminated on Honeywell Voyager 1450g2DHR?
If the aimer isn’t illuminated on your Honeywell Scanner, verify that: * The cable is connected properly. * The host system power is on (if external power isn’t used). * The trigger works.
Instructions for connecting the scanner via USB, keyboard wedge, RS232, and RS485 interfaces.
Using pre-defined bar codes for quick scanner setup for common interfaces like USB and RS232.
Step-by-step instructions for establishing a wireless connection between the scanner and its base.
How to store bar code data when out of range or for inventory purposes, with various modes.
Configuration of beeper and LED feedback for successful reads, errors, and menu changes.
Procedure to restore the scanner to its original factory default settings and disable plugins.
Detailed technical specifications for the Voyager 1450g scanner, including mechanical, electrical, and scan performance.
Technical specifications for the Voyager 1452g cordless scanner, covering radio, battery, and environmental data.
Guide to diagnosing and resolving issues with corded scanners, covering power, reading, and data entry.
Steps to diagnose problems with cordless scanners, bases, and access points, including LED indicators.
To Next Page
General