Need help?Do you have a question about the Honeywell XNX-UTAI Series and is the answer not in the manual?
General| Product Type | Universal Transmitter |
|---|---|
| Material | Aluminum or Stainless Steel |
| Input | mV, RTD, TC |
| Output | 4-20 mA HART |
| Display | LCD with backlight |
| Operating Temperature | -40 °C to +65 °C (-40 °F to +149 °F) (depending on sensor and approvals) |
| Hazardous Area Approvals | ATEX, IECEx, CSA |
| Communication | HART |
| Measurement Range | Depends on input type |
| Accuracy | Varies depending on sensor type and range |
| Response Time | Varies depending on sensor type |
| Enclosure Rating | IP66 |
Covers safety practices, handling, disposal, and installation warnings.
Details requirements for safe installation in hazardous areas, including conduit and enclosure specifications.
Covers sensor placement, transmitter mounting options, and required clearances for installation.
Details wiring considerations, power sources, wire selection, and port assignments for various configurations.
Guides for installing EC, mV, and IR sensors, including remote mounting and generic mA devices.
Covers gas calibration menus, zero/span procedures for various sensors, and bump testing.
Provides instructions for replacing MPD sensor cartridges and EC sensor cells.
Lists EC replacement sensors/cells, MPD cartridges, and various accessories.
Outlines the limited product warranty terms, conditions, and consumer claims process.
To Next Page