Warnings
7.6.
16. Do not operate or use the appliance without the
dust bag and/or filters in place.
17. Before vacuuming, remove any large or sharp
objects from the floor or cleaning surface in order
to prevent damage to the filter.
18. If the air inlet, floor head or the telescopic tube
is blocked, switch off the cleaner straight away
and remove from the mains power. First clear
the blocked object before attempting to start the
cleaner vacuum again.
19. Hold the plug when rewinding onto the cord reel.
To prevent accidental injury do not allow the plug
to whip when rewinding.
20. Do not extend the power cable beyond the
yellow mark.
21. Do not leave the appliance unattended when it is
connected to a mains power supply.
22. Before carry out any maintenance service
or cleaning the filters, always switch off the
vacuum cleaner and disconnect the plug
from power supply.
23. Keep ends of the hose, telescopic tube and
other openings away from your face and body.
24. Do not use the vacuum cleaner if it is damaged
or breaks down. Check the electrical regularly
for defects. If connection cables, electrical
hoses, electrical contacts and electric tubes are
damaged, have them replace immediately.
25. Never clean the vacuum cleaner or any of
the electrical parts, especially the electrical
connections with water or liquid cleaners.
26. Never attempt to make any modifications
electrically to the vacuum cleaner.
27. Always store the appliance indoors in a cool
and dry place.
28. Do not pick up water, dry household use only.
29. Damage caused by improper use or by not
observing the instructions in this manual will
void warranty.
Vacuum Cleaner with Power Head
1. The electric hose contains electrical connections;
- Do not immerse it in water for cleaning;
- The hose should be checked regularly and
must not be used if damaged.
- The vacuum cleaner handle contains
electrical connections the handle is not a
serviceable part
- The vacuum cleaner rod contains electrical
connections the rod is not a serviceable part
- The vacuum cleaner powerhead contains
electrical connections the powerhead is not
a serviceable part
2. Use the electric power head only for vacuuming
dust and dry substances in the home.
3. Never run over the power cable with the power
head as the cable could get damaged.
4. Never touch the brush roller while the vacuum
cleaner is connected to the mains.
5. To prevent unnecessary wear on the power
head cleaning nozzle keeps it moving while
in operation.
Safety Precautions & Warnings Assembling the Vacuum Cleaner
IMPORTANT! Always remove the plug from the power socket before fitting
or removing accessories.
1. Fitting or Removing the Flexible Hose
Fitting:
Insert the flexible hose into the air inlet of the vacuum. Press until it
clicks into position.
Removing:
Remove the plug from the power socket and then release the flexible
hose from the air inlet by depressing the two buttons.
b. Fit the floor head to the telescopic tube, gently insert the
telescopic tube into the floor head and push until it clicks
in place.
You will hear the click sound.
2. Fitting the Telescopic Tube
and Accessories
Important: Ensure the powerhead switch on the handle is
in the “off” position before fitting the handle to the tube.
a. Fit the telescopic tube to the handle, gently insert the handle
into the telescopic tube and push until it clicks in place.
To Next Page
Loading...
