Maintenance
11.10.
Maintenance
IMPORTANT! Ensure the vacuum cleaner is not connected to the power supply
when performing any maintenance procedures. Use a damp cloth and mild
detergent when cleaning the appliance.
Vacuum Cleaner Storage
When not in use, ensure the cleaner is not connected to the power supply, and pull the power cable
gently out of the power socket. Press the automatic cord rewind button to reel in the power cable fully.
Hang the floor brush onto the floor park. The powerhead must be stored separately. Store the cleaner
in a cool dry location.
Changing the Dust Bag
Always operate the cleaner with dust bag installed. If you
forget to attach the dust bag or attach it in the wrong
direction, the dust bag cover may not close completely.
1. Remove the hose from the inlet.
2. Open the cover.
3. Remove the dust bag holder and dust bag from
the machine.
4. Remove the dust bag when it is full and replace bag
by sliding a new dust bag into the bag holder in the
direction of the arrow.
5. Replace the bag holder and bag into the machine.
6. Gently close the cover, you will hear it click closed.
Motor Filter Replacement
WARNING! Ensure the cleaner is not connected to the power supply when
performing any maintenance procedure.
• The inlet filter should be cleaned at least twice a year or
when it becomes visibly dirty.
• Always operate the cleaner with all clean filters installed.
Otherwise, suction power is reduced or motor damage
may be result.
• Do not use a washing machine to wash the inlet filter.
• Do not use hair drier to dry clean the filter.
1. Pull out the filter bracket assembly.
• Separate the filter from the bracket assembly.
• Replace with a new filter and reinstall the filter bracket
back in the vacuum.
Exhaust Filter Cleaning or Replacement
1. Open the dust bag cover and remove the exhaust filter.
2. Clean the filter with lukewarm water (no soap) and allow
24 hours to air dry before reinstalling.
3. It is recommended to replace the exhaust filter every
6 months.
To Next Page
Loading...
