Assembly
9.8.
Assembling the Vacuum Cleaner
Ideal for picking up pet hair on upholstery.
Note: The hand turbo brush adaptor must be used to fit the telescopic
tube to the accessory.
1. Insert the smaller end of the adaptor into the end of the hand turbo brush.
2. Insert the larger end of the adaptor into your handle or telescopic rod.
3. The hand turbo tool is now ready to be used with the vacuum.
Note: Unlock the side release buttons by sliding them up or down as
required. This will allow you to rotate the rubber external bristle to face
upwards, allowing a closer clean as required.
Hand Turbo Brush
Combination Floor Head: For use on hard
floors and carpet.
Powerhead: For use on carpet for a deep clean.
Crevice tool: For radiators, crevices, corners,
baseboards and between cushions.
Upholstery tool: For vacuuming furniture
and upholstery.
Dusting brush: For furniture, blinds, bookshelves
and lamp shades.
Hand Turbo Tool: For removing pet hair and dirt
from upholstery and bedding.
Accessories
Ideal for daily cleaning on carpets
and hard floors*.
* Powerhead is NOT ideal for
hard floors
Carpet Hard Floors
*
Instructions for Use
Before using the appliance, unwind a sufficient length of cable and insert the
plug into the power socket. A yellow mark on the power cable shows the ideal
cable length. Don’t expend the cable beyond the red mark.
1. Press the ON/OFF button to turn the vacuum on.
2. To rewind the power cable, press the retract button
with one hand and guide the cable with the other hand
to ensure that it does not whip causing damage to
the cable.
3. Press the ON/OFF button on the handle to operate
the powerhead.
On/Off
button
To Next Page
Loading...
