6
How To Use:
•IMPORTANT•
This unit is equipped with a smart panel that senses your
touch. Heavy pushing of buttons is not recommended.
CHECK the air purier for the lters. Be sure the supplied lters are
properly in place and all plastic is removed before turning the unit on.
PLACE the air purier on a hard surface such as the oor, a table or
desk. Be sure the grilles are not blocked by other objects, and there
are no candles or ames near the unit.
1
2
3
4
5
6
7
8
PLUG IN into nearest standard electrical outlet.
LIGHTLY TOUCH the power button to turn the air purier on.
Touch the power button again to turn the air purier off.
SELECT THE FAN SPEED To select the speed, lightly touch
and release the fan speed button until the desired speed is reached.
ADJUST THE TIMER The unit will turn off once it runs for the
selected hours.
Note: The unit will run continuously if all the timer lights are off.
THE CHECK FILTER LIGHTS when the lter needs to be
replaced. Once replaced, touch and hold the button for several
seconds until the lter indicator light shuts off. .
HOW THE ap07 PURIFIER WORKS:
An air purier draws in room air from its air intake, lets the air pass through a
single lter that consists of a pre-lter, activated carbon lter and HEPA lter
inside of the unit, then discharges the air from its air outlet. The air purier
repeats this process by moving its internal fan. As air passes through, the
HEPA Filter can remove dust particles. The Active Carbon Filter gradually
absorbs odour elements as they repeatedly pass through the lter.
Some odour ingredients absorbed by the lters may become separated
and may be discharged through the air outlet and result in additional odour.
Depending on the usage environment, this odour may become strong in a
shorter period than expected.
Choosing a Location:
To maximize air circulation, position the air purier at least 50cm away from
walls, or any other large objects that could disrupt airow. For optimum
results close all windows and doors. For more efcient air treatment, place
the unit in a central location and make sure the control panel can easily be
accessed. For specic requirements and circumstances, please contact
your local representative.
LIGHTLY TOUCH ION control to switch ionisation on/off.
Hoover_AirmagMini_250516_manual_P160075_GB_TC_HK ver.indb 9 26/05/2016 4:51 PM