Withcordhook(B)tobackofcleaner,
pushupperhandledownontocleaner.
Insertscrewwithwasherinfrontof
tankarea.Tightenscrewwitha
Phillipsscrewdriver.
Inserttwoscrewsintobackofhandle
asshown.Tightenwitha Phillips
screwdriver.
Pushbrushcontrolswitch(C)downto
connectswitchrod.Youwillheara
"click"whentheswitchrodisin
place.
f
/
i Liiili i
Replace clean solution tank by posi-
tioning bottom first. Press latch and
snap top portion into place.
To install brushes, place handle in
upright position. Tilt cleaner back so
that it rests on the floor.
Align post (D) on brush block with
hole (E) on bottom of cleaner. Turn
brushes slightly until post fits easily
into hole.
Press brush assembly firmly to snap
into place.
To install nozzle, make sure latches
(F) are out.
Align middle section (G) of nozzle
with opening (H) on cleaner.
Remove cardboard packing insert
from squeegee area on underside of
nozzle.
While holding nozzle in place, slide
latches inward to lock in place.
Cord dip
To help keep the cord out of the way
while cleaning, position cord down
into cord clip (I), located on the
handle.
To Next Page
Loading...
