3.3 ELECTRIC CONNECTION AND SECURITY
During the electric connection, surely follow the instructions below.
The earthing cable must be connected to the terminal. You have to ensure the
cable with insulation to be connected to the power source during the connection of
cable. If there is not any appropriate earthed electric outlet in accordance with
regulations in the place where the apparatus will be installed, immediately contact to
our authorized service.
The earthed electric outlet must be close to the apparatus. Surely do not use the
extension cord.
The feeding cable must not touch to the hot surface of the product.
In case the feeding cable is damaged, surely contact to Qualified Service. The
cable must be changed by the authorized service.
The wrong electric connection may damage your apparatus. Such damage is not
in guarantee extent.
The apparatus is adjusted as appropriate for 220-240 Volts and 400V 3N Volts
of electricity. If the network electricity is different than this informed value, immediately
contact to our authorized service.
The electric cable must not touch to the hot parts of apparatus. The electric cable
must not touch the back part of the apparatus. Otherwise the electric cable of
apparatus may be damaged. And this situation may cause short circuit.
The producer firm declares that it has no responsibility against any kind of damages
and losses that emanate from the following security norms.
There is to install an all pole disconnector inside the supply circuit with a contact
opening of at least 3.0mm rated 32A and delay functioning type.
6
3. 2 ADJUSTMENT OF FEET
Your oven stands on 4 adjustable feet. As the feet are adjusted in low location, it is
required to control whether it is balanced before installing the oven. You can make
this adjustment as turning the feet clockwise if required. It is possible to raise the
apparatus maximum 15 mm via the feet.
If the feet are adjusted appropriately, it is required not to move the apparatus by
dragging, otherwise it is required to place it by lifting it up. It is required to bring the
ovens drawer out to adjust the apparatuss feet. The feet can be adjusted from inside
via the small change.
To Next Page
Loading...
Need help?
General
