ASSEMBLING YOUR CLEANER The cleaner should be switched
off and disconnected from the mains supply before you start to
assemble.
1. Connect the hose body connector to
the cleaner.
2. Insert the wand into the all-purpose
oor tool.
3. Fit the other end of the telescopic
wand to the hand piece, making sure
of a tight t.
5. Never extend the power cord further
than the white mark.
6. Suction can be varied by opening or
closing the slider control.
4. You can extend or reduce the length
of the wand by moving the slider.
5
WHITE MARK
To Next Page
Loading...
Need help?
General
