CHANGING FILTERS
The cleaner should be switched off and disconnected from the mains
supply. Never operate without lters as damage to cleaner could occur.
1. Open dust bag housing and lift up
and remove bag assembly.
2. Bag removed allowing easy access
to motor lter.
4. To gain access to HEPA lter lift
rear lter cover.
3. Remove the motor lter by lifting
up. Discard lter and replace with
new and ret.
5. With lter cover removed, lift out
dirty HEPA lter and discard.
6. Fit new HEPA lter and ret cover.
7
To Next Page
Loading...
