Why my Hoover HSX4 1475T3/1-S does not work / start?
If your Hoover Washer isn't starting, ensure it's properly plugged into a working socket and that the power is on. Test the wall socket with another appliance. Also, make sure the door is correctly closed, the correct program is selected, the start button is pressed, and that the washer isn't in pause or time delay mode.
Why the Hoover HSX4 1475T3/1-S Washer does not spin?
If your Hoover Washer isn't spinning, first remove and de-tangle the load, then reload it and restart the spin program. It could also be due to incomplete water drainage, so wait a few minutes. Ensure that the 'no spin' function isn't selected and that the correct amount of detergent is used, as excessive detergent can impede the spin cycle. Check the selected options and their effect on the spin cycle.
What to do if water leaked on the floor near the Hoover Washer?
If you find water on the floor near your Hoover Washer, it could be due to a leak from the seal between the tap, supply hose, and fill valve. Try replacing the seal and tightening the hose connections. Also, check that the front filter is correctly closed.
What to do if Hoover HSX4 1475T3/1-S shows error E3?
If your Hoover Washer displays error code E3 or shows 3 LED flashes, check that the filter is not clogged and that there are no foreign objects inside the filter compartment. Also, make sure the drain hose isn’t bent or trapped and that the home drainage system is not blocked.
Why strong vibrations / noises are heard during the spin cycle of my Hoover HSX4 1475T3/1-S Washer?
Loud vibrations or noises during the spin cycle of your Hoover Washer can occur if the appliance isn't fully leveled. Adjust the feet as needed. Ensure that transport screws, rubber bungs, and spacer tubes have been removed. Also, check for any foreign objects like coins or buttons inside the drum.
How to fix Hoover HSX4 1475T3/1-S error code E2?
If your Hoover Washer displays error code E2 or shows 2 LED flashes, make sure the water supply tap is open and the supply hose isn’t bent or trapped. Ensure the drain pipe is at the correct height. Clean the “anti-sand” filter after closing the water supply tap and unscrewing the filler hose. Check the filter for clogs or foreign objects.
How to fix Hoover HSX4 1475T3/1-S Washer error code E7?
If your Hoover Washer displays error code E7 or shows 7 LED flashes, make sure the door is correctly closed and that clothes inside the drum aren't preventing it from closing fully. If the door is locked, turn off and unplug the washing machine, wait 2-3 minutes, and then reopen the door.
What does error E4 mean on Hoover Washer?
If your Hoover Washer displays error code E4 or shows 4 LED flashes, ensure you are using the correct amount of detergent and that it is designed for washing machines.
General| Maximum Spin Speed (RPM) | 1400 |
|---|---|
| Washer Capacity (Kg) | 7 |
| Capacity | 7 Kg |
| Spin speed | 1400 RPM |
| Noise level (washing) | 58 dB |
| Noise level (spinning) | 79 dB |
| Number of programs | 15 |
| Dimensions (H x W x D) | 85 x 60 x 45 cm |
To Next Page