17
LUBRICATION
The motor is equipped with bearings which contain sufcient lubrication for its lifetime.
The addition of lubrication could cause damage. Do not add lubrication to motor.
HEXAGUARD
™
ACTIVATED
CARBON FILTER
INLET FILTER
The inlet lter is located on the inside,
bottom of bag housing and protects
the motor from damage.
1
The HexaGuard
™
Filters are
located on the inside of the lter
door. Pull to remove.
1
If the lter becomes dirty, pull
off the grill and lift out the lter.
Hand rinse in cold water under
low pressure. Let lter dry for 24
hours. Reposition dry lter and
snap grill into place.
REPLACEMENT
FILTER
Replace HexaGuard
™
Filter yearly for optimum
performance.
Part No. 440009176
REPLACEMENT
FILTER
Inspect Inlet Filter every
2 weeks to keep vacuum
running at peak performance.
Part No. 440009175
Filters
WARNING:
TO REDUCE THE RISK OF PERSONAL INJURY – REMOVE BATTERY BEFORE CLEANING
OR SERVICING. DO NOT OPERATE VACUUM WITHOUT BOTH INLET FILTER AND FINAL FILTERS IN PLACE.
IMPORTANT:
ALLOW FILTER TO DRY COMPLETELY BEFORE REPLACING. DRY FILTER ON
EDGE SO AIR CIRCULATES ON BOTH SIDES OF FILTER. THIS MAY TAKE UP TO 24 HOURS.
FILTERS
To Next Page
Loading...
Need help?
General
