7
NOTE: For best results, use straight, parallel strokes.
Overlap strokes by 1 in. to help prevent streaking.
1 42 3
Plug in. Step on the
handle release pedal to
put unit in
cleaning position.
Release the trigger and
slowly push forward over
the sprayed area. Then
slowly pull back toward
you without squeezing
trigger (dry stroke).
Continue using dry
strokes until little water
is visible passing through
the nozzle.
Step on the power pedal
to turn ON (I=ON). Press
the power pedal again to
turn OFF (0=OFF).
Squeeze trigger to apply
cleaning solution. Slowly
push forward then backwards
while squeezing the trigger
(wet stroke).
Using your Power Path
™
Pro:
To Next Page
Loading...
