1. Assembling cleaner
Carton contents
Unpack cleaner from carton and identify the
parts shown. Remove and dispose of
cardboard packing.
B
_ E
(_ E
@F
Ill
Stand base in upright position. Push
midsection onto base by aligning tabs on
the backside of midsection and the pockets
on the backside of base. Assemble the two
(2) lower handle screws in the following
manner: while holding nut in place, insert
screw through front of midsection and
tighten.
NOTE: Make sure the power cord is out of
the way to avoid pinching.
Slide upper handle
down onto unit.
Place screw into
recess in back of
upper handle and
tighten.
A. Upper Handle
B. Midsection
C. Base
D. (1) Upper Handle screw
E (2) Right and Left Base Screws
F. (3) Nuts
Operate cleaner only at voltage specified on
data plate on back of cleaner.
Place solution reservoir into cleaner and tilt
back until it snaps into place.
To Next Page
Loading...
