To Next PageTo Next PageWhy my Hoover UH70930 won’t run?
The Hoover Vacuum Cleaner might not run due to several reasons: the power cord may not be firmly plugged in, so ensure it is properly connected. A blown fuse or tripped breaker in your home could be the issue; check and replace the fuse or reset the breaker. Alternatively, the thermal protector might have activated; unplug the vacuum and allow it to cool for 30 minutes to reset it.
Why does my Hoover UH70930 have no suction?
If your Hoover Vacuum Cleaner has low suction, the system check indicator turns red, or it won’t pick up, there might be several causes. The rinsable filter or HEPA media filter could be dirty, so you should clean it. The dirt cup might be full or clogged, so you should empty it. A broken or worn belt could be the problem, requiring a replacement. The brushroll or hose might be clogged, so you should check and clear them. The carpet height setting could be incorrect, so adjust it appropriately. Lastly, the Suction Only Mode might be on; turn it off using the Brushroll ON/OFF Pedal.
How to make my Hoover UH70930 Vacuum Cleaner easier to push?
If your Hoover Vacuum Cleaner is difficult to push, it could be due to an incorrect carpet height setting, so adjust the carpet height adjustment knob. Alternatively, the brushroll might be activated; for very high pile carpet deeper than 1 inch, turn the brushroll off.
What to do if the brushroll on my Hoover UH70930 Vacuum Cleaner hand tool won’t turn?
If the air-powered hand tool brushroll on your Hoover Vacuum Cleaner won’t turn, it might be because too much pressure is being applied to the tool, so use light pressure. Alternatively, there could be a blockage, so remove it. Low vacuum suction could also be the cause; check the items under “Vacuum won’t pick up or Low suction.”
Why is dust escaping from my Hoover Vacuum Cleaner?
Dust escaping from your Hoover Vacuum Cleaner can be due to a few reasons: the dirt cup might be full, so empty it. It could also be that the dirt cup or the hose is not installed correctly, so review their installation. Another possibility is that the rinsable filter or HEPA media filter is not installed completely, so review the filter removal and cleaning instructions.
Why does my Hoover UH70930 have a burning smell?
If you detect a smoky or burning smell from your Hoover Vacuum Cleaner, it could be due to a broken or stretched belt, so replace the brushroll belt. Another cause could be a clogged brushroll, so clear any debris from it.
Why is the headlight not working on my Hoover UH70930 Vacuum Cleaner?
If the headlight on your Hoover Vacuum Cleaner is not working, it could be due to a burnt-out bulb.
General| Brand | Hoover |
|---|---|
| Model | UH70930 |
| Category | Vacuum Cleaner |
| Language | English |
