EasyManuals Logo

Hoover VisionHF User Manual

Hoover VisionHF
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
1. Open the door and load the drum with laundry. Ensure
that garments do not hinder closure of the door.
2. Gently close the door pushing it slowly until you hear the
door 'click' shut.
3. Press the On/Off button to switch on the dryer. The
On/Off indicator will light up and the START indicator will
flash.
4. Turn the Programme Selector dial to select the required
drying programme (see Programme Guide).
5. If drying synthetics, acrylics or delicate items, press the
Acrylic/Synthetic button to reduce the heat level.
The light above the push button will light up when the
machine is in low heat setting. To deselect this status the
machine must be reset.
6. Press the Start/Pause button. The dryer will start
automatically and the START indicator will be
continuously lit.
7. The display will show the drying progress in terms of time
remaining.
8. If the door is opened during the programme to check the
laundry, it is necessary to press Start/Pause to recommence
drying after the door has been closed.
9. When the 15' indicator is lit the machine will enter the
cool down phase, the clothes will be tumbled in cool air
allowing the load to cool down.
10. When the programme is complete the STOP indicator will
light.
11. Following the completion of the cycle the drum will
rotate intermittently to minimise creasing. This will
continue until the machine is reset or switched OFF.
Cancelling and resetting the
programme
To cancel a programme switch the machine off and on again.
The machine will indicate that it has been reset by the START
indicator flashing.
Delay Start
The Delay Start function allows the user to delay the start of
the drying cycle by 6 or 9 hours.
When the function is first selected the display will show a
delay of 6 hours, a subsequent press of the button will increase
the delay to 9 hours.
To commence the programme press Delay Start and the
appliance will complete the drying cycle at the end of this
time. The 6 or 9 hour indicator light will flash to indicate that
the start delay is in progress.
16
Operation
WARNING!
The drum, door and
load may be very hot.
40005181.qxd 19/07/2007 12:36 Page 16

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hoover VisionHF and is the answer not in the manual?

Hoover VisionHF Specifications

General IconGeneral
BrandHoover
ModelVisionHF
CategoryDryer
LanguageEnglish

Related product manuals