How do I fix error code E-41 on my horiba HU-200TB-W SS-120-W?
If you are getting error code E-41 on your Horiba Measuring Instruments, clean the measuring cell and try zero calibration with clean water.
What should I do if error code E-81 appears on my horiba HU-200TB-W SS-120-W?
If you receive error code E-81 on your Horiba Measuring Instruments, turn OFF the power supply and turn it ON again.
General| Brand | horiba |
|---|---|
| Model | HU-200TB-W SS-120-W |
| Category | Measuring Instruments |
| Language | English |
Details HORIBA's warranty terms and limitations for the product.
Lists registered and unregistered trademarks mentioned in the manual.
Lists directives and standards the equipment conforms to, including EMC, Safety, and RoHS.
Explains hazard classifications (DANGER, WARNING, CAUTION) and warning symbols used.
Provides critical safety measures to prevent injury and product damage.
Provides essential precautions for operating the product safely and maintaining performance.
Advises on proper disposal of the product according to local laws and regulations.
Explains the meaning of notes, references, and tips used in the manual.
Defines key terms used throughout the manual for clarity.
Introduces the product, its measurement method, range, and standards.
Details the features of the converter and detector, including optional automatic cleaner.
Provides instructions for unpacking the product and checking its contents for completeness.
Identifies and describes the main parts and functions of the converter.
Explains the function of each key used for operation, settings, and calibration.
Describes the meaning of various indicators and lamps on the status display.
Details the different operation modes and menu items accessible from the measurement screen.
Specifies the required environmental conditions for installing the converter and detector.
Describes the methods for installing the converter and detector.
Covers piping for sample flow and considerations for sampling.
Details terminal block connections for power supply, outputs, inputs, and communication.
Outlines initial procedures for using the converter, including preparation and setup.
Guides on changing initial settings via the setup menu, including standard substance and unit selection.
Covers detailed settings for automatic calibration, contact output, transmission output, and cleaning.
Defines conditions for automatic cleaning and zero calibration start.
Describes how to turn on the power and enter the normal measurement mode.
Explains how to enter the setup menu to configure parameters like standard substance, units, display, and outputs.
Guides on entering the calibration menu for zero and span calibration.
Explains how to enter the user check menu to verify display, output, or initialize settings.
Covers calibration methods, focusing on zero and span calibration procedures.
Details the zero calibration process, including automatic and manual methods, and checking calibration data.
Explains the span calibration procedure, including standard solution preparation and SS adjustment.
Provides instructions for cleaning the detector's cell and sampling piping.
Details procedures for replacing the automatic cleaner's wiper and motor.
Lists common measurement issues, their possible causes, and remedial actions.
Lists various error codes displayed by the converter, their descriptions, and remedial actions.
Provides detailed technical specifications for the converter, detector, and optional accessories.
Explains the 90-degree transmission-scattering method using an LED light source.
Provides detailed steps for preparing Formazin and Kaolin calibration solutions.
Lists consumable and replacement parts with specifications and part numbers.
To Next Page