Horizon Hobby A-10 - User Manual

Questions and Answers

L
lbarberJul 27, 2025
Why is my Horizon Hobby A-10 aircraft flight time reduced?
- J
  Jack OsborneJul 27, 2025
  If you're experiencing reduced flight time or your Horizon Hobby Tools aircraft feels underpowered, several factors could be at play. First, ensure your flight battery is fully recharged. If the issue persists, the battery might be damaged and require replacement, following the battery instructions. Cold flight conditions can also impact performance, so warm the battery before use. Consider whether the battery capacity is suitable for the flight conditions; a larger capacity battery might be necessary. Also, during binding, ensure the transmitter isn't too close to the aircraft; move it further away and repeat the binding process. Finally, confirm the bind switch or button was held long enough during binding; repeat the process, holding until the receiver is bound.
K
Kristina SmithAug 1, 2025
What to do if Horizon Hobby A-10 aircraft won't respond to throttle?
- S
  smithlukeAug 1, 2025
  If your Horizon Hobby Tools aircraft isn't responding to the throttle but responds to other controls, there are several things you can check. First, make sure the throttle stick and throttle trim are at their lowest settings. If that doesn't work, the throttle channel might be reversed; reverse it on the transmitter. Also, check that the motor is properly connected to the receiver by opening the fuselage. Finally, ensure that the flight battery is fully charged.
T
Taylor BradfordAug 6, 2025
Why is there extra motor noise or vibration in my Horizon Hobby Tools?
- M
  Michael HarrisAug 6, 2025
  If you notice extra motor noise or vibration in your Horizon Hobby Tools, it could be due to a damaged rotor or motor; in this case, replace the damaged parts. Another possibility is that the rotor is out of balance; try balancing or replacing it.
K
Kimberly McmahonAug 11, 2025
Why are my Horizon Hobby Tools model files inconsistent?
- D
  David PerezAug 11, 2025
  If you are experiencing inconsistent model files from flight to flight with your Horizon Hobby Tools, it may be because the aircraft was not kept immobile for 5 seconds after the battery was plugged in. Make sure to keep the aircraft immobile for 5 seconds after plugging in the battery. Another cause may be that the trims are moved too far from the neutral position. In this case, neutralize the trims and mechanically adjust the linkages to center the control surfaces.
J
johnsonkathrynAug 15, 2025
How to fix Horizon Hobby A-10 Tools control surfaces not at neutral?
- K
  Kristina GarciaAug 16, 2025
  If the control surfaces of your Horizon Hobby Tools are not at the neutral position when the transmitter controls are at neutral, it could be that the control surfaces may not have been mechanically centered from the factory. To fix this, center control surfaces mechanically by adjusting the U-bends on control linkages. Another cause could be that the aircraft was moved after the flight battery was connected and before the sensors initialized. If this is the case, disconnect and reconnect the flight battery while keeping the aircraft still for 5 seconds.
D
Dustin FloresAug 20, 2025
What to do if Horizon Hobby Tools controls oscillate in flight?
- J
  Jonathan ThompsonAug 20, 2025
  If the controls of your Horizon Hobby Tools oscillate in flight (the model rapidly jumps or moves), the rotor might be unbalanced, causing excessive vibration. Remove the rotor and motor, check the motor shaft for straightness, and replace the rotor if damaged.